We built these 1000W and 2000W infrared halogen lamps to slide right into the spot of your old ones—no messing around. They’re made to take the heat of industrial work without blinking. And that 354mm length? Chosen on purpose so it matches what’s already in your machine. Drop it in, bolt it down, and you’re good. No re-engineering. No extra trips to the hardware store.
Power and fit: why it matters
Wattage is the heartbeat here. The 1000W gives you steady, controlled warmth for smaller areas. The 2000W? That’s for the heavy-duty jobs that need serious heat density. These lamps come alive in seconds. That means your machine warms up fast, so you’re not waiting around on the floor. But here’s the part you don’t want to miss: that quick start-up is a power hit. Make sure your wiring and control circuitry can handle the surge. If they can’t, you’ll chew through contactors way too soon.
Inside the lamp: simple, tough, reliable
Inside, the halogen cycle keeps the filament clean, so the output stays steady over the life of the lamp. The quartz envelope can take the shock of switching on and off again and again. And the R7s connector is a double-ended pin that just clicks in place on machines already set up for linear halogen heaters. It’s a solid, no-fuss connection that holds steady under the current. No wiggle. No worries.
Where it shines
This setup is built for industrial heating where you need focused infrared—think plastic work like PET blowing and thermoforming, where you need heat fast and right where you point it. Because it’s 354mm long and uses that R7s termination, swapping out a tired heater is quick. Wire it up, dial in the control, and run. One thing to keep in mind: at 2000W, the surface gets seriously hot. Shield it properly and make sure airflow is in place to keep nearby parts safe.