500mm on Warm Light Source

500mm halogen heat lamp oven

Tue, 02 Jun 2026 02:36:54 +0800

Getting the Power and Size Right

When we built the 500mm halogen heat lamp, we had one clear goal: make it tough enough for industrial ovens that run hot, fast, and long. That 500mm length isn’t random. It gives you a big, solid radiant surface, so heat spreads evenly across a wide area. No patchy spots. No guesswork. It’s sized to drop right into standard oven chambers, so coverage stays consistent from corner to corner. And the power? It runs at high wattage because industrial work demands serious heat flux. That’s what gives you quick ramp-up, so your cycles finish faster and your line keeps moving.

Halogen Lamp Replacement Parts 500mm 1300w for Blowing Machines

Wed, 27 May 2026 22:14:46 +0800

We built this 1300W halogen lamp to be the heat source your blowing machine has been waiting for. It’s made to slot straight in where your old heater lived, especially when you’re heating PET preforms and molding bottles. If you’re replacing a worn-out heater, this one is designed to be a true drop-in. It matches the 500mm mounting footprint, so you don’t have to fight with new brackets or rework the space. Power and fit, without the fuss The 1300W rating is all about packing serious heat into a small space. And that 500mm length? It’s the standard size for these machines, which means it covers the whole parison and mold area evenly. No hot spots. Just consistent heat. That power helps the temperature snap back fast, so your cycles don’t drag. But here’s the thing: it runs hot. So make sure your machine’s cooling and airflow are in good shape. That keeps everything around it from getting cooked. Built to take the heat The lamp sits inside a quartz envelope, which can handle the high output and the halogen cycle that keeps the filament stable for thousands of hours. A reflective coating pushes infrared energy forward, so more of the heat goes where you need it. It’s fitted with an R7s connector. That double-ended pin setup locks the lamp in tight—mechanically and electrically. No wiggle. No surprises. Just a solid connection that stays put. Swap it in and get back to work On the blowing machine, this lamp heats the PET preforms quickly and evenly. The 500mm length and R7s connector make the swap simple. No rewiring. No custom fabrication. And the halogen chemistry keeps output steady, even after repeated heating and cooling. That kind of reliability means less downtime and more uptime. Just match the voltage, check the clearance, and wire it up. This lamp is ready to carry the thermal load and keep your machine running.

SK15 Halogen Infaraed Heat Lamp 500mm 1200w for Flash Cure

Wed, 29 Apr 2026 19:04:04 +0800

SK15 Halogen Infrared Heat Lamp: 1200W, 500mm for High-Speed Flash Cure Systems

We built the SK15 Halogen Infrared Heat Lamp for one reason: to nail that target line on your flash cure setup—without hesitation. Here’s the heart of it: 1200W packed into a 500mm quartz tube, sitting on a tough SK15 base. That combo gives you a heat source that’s small enough to squeeze into tight spots, yet strong enough to deliver the thermal punch you need for fast curing.