Customize 920MM 220V 1200W Halogen Lamp Replacement Parts

May 13, 2026

Introduction

We built this 920mm halogen lamp to be a straight swap for industrial heating setups. The whole point? Give you steady, high-intensity heat in a small footprint—and make it drop right into the fixtures you already have, so you don’t have to re-engineer the machine.

Power, voltage, and size—why it matters

At 1200W and 220V, it’s matched to the power you’ll find in most plants, so the heat output stays predictable. That wattage packs a punch—high heat density, exactly what you need when you’re heating plastics, seals, and smaller parts fast. Then there’s the 920mm length. It gives you a long heating zone, so you get even temperature across a bigger area without stacking heaters. And it keeps the hottest part farther away from nearby wiring and sensors, so you don’t end up with heat soaking into components you’d rather keep cool.

What’s inside, and why it holds up

Inside, a halogen capsule sits in a quartz tube. That combo keeps the filament stable when things get seriously hot, so the bulb can run hotter than standard infrared lamps. The payoff is consistency—output stays steady over time, so your cycle temperatures repeat, shift after shift. The R7s end-cap connector is the kind of industrial fit you can count on. It carries the current, makes mounting straightforward, and gives you a clean two-point wire-up. When a lamp goes down, that means less downtime getting back online.

Where it shines—and what to watch for

This lamp shines as a replacement in heating stations where space is tight but thermal output can’t dip. It heats up quickly, installs quickly, and keeps temperature control repeatable. Just keep one thing in mind: it runs hot at the surface. Make sure your fixture and any shielding around it are rated for that heat. It’s a true drop-in part, but before you wire it up, double-check clearances and make sure cooling around the lamp is where it needs to be.