Halogen Lamp Replacement Parts 500mm 1300w for Blowing Machines

May 27, 2026

We built this 1300W halogen lamp to be the heat source your blowing machine has been waiting for. It’s made to slot straight in where your old heater lived, especially when you’re heating PET preforms and molding bottles. If you’re replacing a worn-out heater, this one is designed to be a true drop-in. It matches the 500mm mounting footprint, so you don’t have to fight with new brackets or rework the space. Power and fit, without the fuss The 1300W rating is all about packing serious heat into a small space. And that 500mm length? It’s the standard size for these machines, which means it covers the whole parison and mold area evenly. No hot spots. Just consistent heat. That power helps the temperature snap back fast, so your cycles don’t drag. But here’s the thing: it runs hot. So make sure your machine’s cooling and airflow are in good shape. That keeps everything around it from getting cooked. Built to take the heat The lamp sits inside a quartz envelope, which can handle the high output and the halogen cycle that keeps the filament stable for thousands of hours. A reflective coating pushes infrared energy forward, so more of the heat goes where you need it. It’s fitted with an R7s connector. That double-ended pin setup locks the lamp in tight—mechanically and electrically. No wiggle. No surprises. Just a solid connection that stays put. Swap it in and get back to work On the blowing machine, this lamp heats the PET preforms quickly and evenly. The 500mm length and R7s connector make the swap simple. No rewiring. No custom fabrication. And the halogen chemistry keeps output steady, even after repeated heating and cooling. That kind of reliability means less downtime and more uptime. Just match the voltage, check the clearance, and wire it up. This lamp is ready to carry the thermal load and keep your machine running.